smart-switch-uk

How to remove swirl marks and cobwebs in a car

Cars are subject to many elements that can scratch and dent their surface. Unfortunately, cleaning the exterior of a car with the wrong product can cause swirl marks or cobwebs. Even automotive detail technicians can inadvertently create these unpleasant problems. With the right tools and products, you can remove swirl marks and cobwebs. Visit this link to gain more ideas: best scratch and swirl remover

Step 1

Wash the car carefully with a product that removes dirt from the road. Be careful to remove insects and tar from all surfaces. Microfiber towels are good to use, because they are less likely to scratch the car's surface. Wash with a towel and rinse with another.

Step 2

Apply the wax to your car with a soft cloth or applicator. Do it on a sunny day, or put your car in the shade. Apply the wax sparingly. Do not add more wax than you can remove within the time specified on the product label.

Step 3

Remove the wax with an orbital polisher or polish. Both should have a soft polishing mat. Work the machines back and forth in a small area to remove swirl marks and cobwebs.

Step 4

Repeat steps 2 and 3 until the car is fully waxed. If you work in small areas at a time, you will be able to reduce or eliminate swirl marks and cobwebs.

Step 5

Seal the newly waxed finish with a protective varnish. This product will give your car a very attractive shine, as well as helping to protect it from everyday dust and dirt.

Step 6

Keep your car clean. Wash it regularly with suitable products to protect its surface.

Refining Polisher Malco Tru Polish 236ML

The automotive refining polisher Malco Tru Polish uses the most advanced abrasive technology available today to remove 3,000 sandpaper scratches, car wash scratches, day-to-day wear and swirls remaining after compounds.
The finish is a true shine, deep and without waxes, fillers or silicones that create a shine that ends after washing. Developed for use in new and old light coating systems. This water-based formula contains special lubricants that allow a long working time and are easy to clean. Can also be used after Tru Grit, Super Duty or Buff Lite.

HOW TO USE:
Shake well before using. To obtain the best results on deeper sandpaper 3000 scratches, use with a refining beret, Apply 2 3 cm lines of Malco Tru Polish to a 40X40 cm section and spread over the surface. Using a speed of 1400-1800 rpm, work slowly with the product using light to medium pressure.
Do not buff if the surface is dry. The polishing compound was designed to be lubricated throughout the polishing for a better finish. If the polishing surface starts to dry, apply more product and continue to polish. For dark cars and light swirls, repeat polishing with a soft beret to bring a swirl free finish.